JeyTee84 Posted May 27, 2019 Share Posted May 27, 2019 I was trying to craft soot-covered redstone (from deep mob learning) by clicking a block of coal with redstone. When I clicked, I crashed and now i crash every time i try to log in. The coal block was placed directly under a gregtech machine. Looking at the crashlog, i'm pretty shure the GTCE machine and the redstone didnt like each other. But its just an idea. I would appreciate it a lot if someone could look into it Thanks a lot in advance. crashlog: https://pastebin.com/PdLMg1RY (installed vanillafix, got pretty much the same crash: https://paste.dimdev.org/mibivoviho.mccrash it also says its probably the GTCE machine) Link to comment Share on other sites More sharing options...
JeyTee84 Posted May 28, 2019 Author Share Posted May 28, 2019 Made an issue report on the FTB github since its caused only by the GTCE machine and the redstone (tested it a few ways in singleplayer): https://github.com/FTBTeam/FTB-Interactions/issues/667 It would be nice to let the players know not to put redstone on blocks around any GTCE machine until its patched because it will cause them the same thing. Also would it be possible to remove the redstone or the GTCE machine in my case? Or do a rollback or something? The chunk cordinates are -1185, 97, 2863 and the block, causing the issue is the one shown in this pic: https://imgur.com/3zng6pP (its an older screenshot, but it shows the GTCE Polarizer thats causing the crashes) Link to comment Share on other sites More sharing options...
DragonLady Posted May 29, 2019 Share Posted May 29, 2019 I went to your base and didn't crash. When I was there I removed the redstone dust in front of the machine so you should be able to go there. Just to be sure, I sent you to spawn Link to comment Share on other sites More sharing options...
JeyTee84 Posted May 30, 2019 Author Share Posted May 30, 2019 Interesting. I made a fresh install and tried it with that and it still crashed both single and multiplayer. Nontheless thanks a lot! I appreciate your help. Link to comment Share on other sites More sharing options...
DragonLady Posted May 30, 2019 Share Posted May 30, 2019 Glad you're able to get online again T/C Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.