Jump to content

Restrict/Warn ME ToggleBus usage.


AtomicGrog

Recommended Posts

With the Omni ME running with no channels, adding/removing devices causes the whole device list to be scanned with every change.

This would be fine if it was only invoked with manual change but unfortunately using a ME toggle bus has the same impact.

And if a toggle bus is used for stock control then when it connects/disconnects the partitioned section it has same outcome, especially when the source/store arrangement has little hysteresis.

Outcome being.. ToggleBus & No Channel ME is a bad combo.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site you agree to the following Terms of Use, Guidelines and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.